P145D BMW Fault Code

Description:

Low Speed Fuel Pump Primary Circuit Malfunction The PCM monitors the low speed fuel pump (LFP) primary circuit output from the PCM.
The test fails if: When the LFP circuit is commanded on (grounded), excessive current draw is detected on the BMW LFP circuit; or when the LFP circuit is commanded off, voltage is not detected on the LFP circuit (the PCM expects to detect VPWR voltage coming through the low speed fuel pump relay coil to the LFP circuit). Open or shorted low fuel pump (LFP) circuit Open VPWR to low speed fuel pump relay Damaged low speed fuel pump relay Damaged PCM An open circuit or short to ground can only be detected with the low speed fuel pump.

P145D Code Symptoms :

When you turn on the ignition, the Service Engine Soon or Check Engine P145D light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the P145D!

Diagnosis And Repairing P145D

P145D OBD2 specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.

How to fix P145D code ?

• Camshaft Position Sensor harness is open or shorted
• Erratic camshaft position due to low oil pressure
• Faulty Mass Air Flow (MAF) sensor
• Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection

One example of this would be when an bmw automatic car in placed in gear. To prevent the added drag from the torque converter and transmission from reducing the idling speed, the PCM will command the idle control valve to allow more air to enter the engine, while at the same time, adjusting the injector pulse width to inject more fuel to suit the increased amount of air. Note that the idle air control valve is closed by the PCM when the throttle plate is opened to prevent excess air from entering the engine.